Cleanroom Sandwich Wall Panel Installation Method (Cnsterilezoom Installation Technical Drawings)

Achieve flawless contamination control and structural precision with our comprehensive guide to the Cleanroom Sandwich Wall Panel Installation Method (Cnsterilezoom Installation Technical Drawings). Designed for high-performance controlled environments, this specialized service pairs premium cleanroom sandwich wall panels with detailed architectural schematics to streamline on-site assembly. Our end-to-end cleanroom installation services provide critical engineering support, precise alignment tolerances, and reliable joint integration essential for pharmaceutical, electronic, and biotechnology facilities. By implementing these standardized procedures, project teams ensure an airtight seal, flush finishes, and full compliance with strict GMP and ISO standards. Optimize your overall modular cleanroom construction timeline while safeguarding operational integrity through proven engineering expertise.

The installation Process of Cleanroom Panel is as Follows:

1. Construction criteria → 2. Measurement and setting out →3. Boom installation →4. Installation of t-type aluminum →5. Geosyncline installation →6. Roof installation →7. Cleanroom wall panel installation →8. Accessories installation →9. Hole cutting →10. Cleanroom door and windows installation →11. Cleanroom seal

How to Install Cleanroom Wall Sandwich Panels? 

1. Cleanroom wall panels installation should be carefully according to the construction drawing line.The corner shall be vertically connected to prevent the wall panel from tilting and twisting. The clean room sandwich panels perpendicularity deviation shall not be greater than 0.15%.

2. Clean the ground and install U slot in the base with the same horizontal size as the line setting, and fix it with M8 expansion bolts with 500mm spacing between the bolts.(node is shown below)

3. After the installation of the biological cleanroom wall panel, the seam gap shall be consistent, and the gap error of each panel shall not be greater than 2mm, and the positive pressure surface shall be uniformly sealed with sealant, which shall be flat and smooth, slightly lower than the plate surface, without any discontinuity or impurities.

4. The electrical junction box on the cleanroom wall panel, the control panel and the various openings where the pipeline passes through should be located correctly, with neat edges, tight, clean, dust-free and sealed with non-combustible or non-combustible materials.

5. The reserved hole for installing cleanroom door and windows should meet the design requirements, and should be smooth, tight, clean and dust-free.

6. The partition plate shall be installed firmly, and the position, quantity, specification, connection method and anti-static method of embedded parts and connecting parts shall meet the design requirements.

7. The wall surface plate shall be installed vertically, flat and in the right position. Anti-cracking measures shall be taken at the junction with the cleanroom ceiling panel and the relevant cleanroom wall panel.The joints shall be sealed.Round corners should be used.

8. The surface of the wall should be smooth, smooth and consistent in color. The mask of the wall panel should be intact (before tearing the film).

9. The allowable deviation and inspection method for wall plate installation shall conform to the requirements in the following table.

If you have decided to renovate or expand a pharmaceutical plant. Now, in the detailed design phase, you need to make critical decisions about the facilities you run, the quality of the materials you build, and the cleanroom panel installation process.At Cnsterilezoom, we have 4 subsidiaries, 13 offices, and more than 100 business and technical personnel located throughout the region to provide customers with timely, face-to-face service.